Expert advice needed Dialog not sounding to good.
|
Joined: Mar 2016
Posts: 37
enthusiast
|
OP
enthusiast
Joined: Mar 2016
Posts: 37 |
For the last week or so I been trying to get the Center dialog on my vp180 to sound less like voices coming out from a box. I tried different crossover setting, re-calibrating ARC also re-check the connection and still doesn't seem to help much. I wonder if I need to upgrade to the HP version and run full range? It's getting frustrating. Also the dialog is very low and doesn't match the soundstage very well. Maybe I'm placing my speaker incorrectly. Any advice would greatly appreciated. Link to a picture I taken of my speaker placement Speaker placement pic
|
|
|
Re: Expert advice needed Dialog not sounding to good.
|
Joined: May 2014
Posts: 1,171 Likes: 6
connoisseur
|
connoisseur
Joined: May 2014
Posts: 1,171 Likes: 6 |
You mention re-calibrating ARC, so am I to assume that you are running an Anthem receiver or pre-amp?
It would be far better off if you are, to provide a copy of the speaker calibration printout. as it's run in Windows, if you load something like CutePDF if you don't have a pdf print or aren't running windows 10.
From the few times that I have played with ARC, I found that the defaults didn't even come close to letting the speaker run as full frequency. There is quite a bit of configuration that you can do inside of ARC. For dialog you will need to give your center speaker a bump around the 120hz to 220hz. it could be that your room is sucking those frequencies down and your are loosing your dialog as a result of that.
Anthem: AVM60, Fosi DAC-Q5 Axiom: ADA1500, LFR1100 Actiive, QS8, EP500, M3, M3comp, M5
|
|
|
Re: Expert advice needed Dialog not sounding to good.
|
Joined: Nov 2015
Posts: 12
frequent flier
|
frequent flier
Joined: Nov 2015
Posts: 12 |
You mentioned checking the connection... just to rule it out, are you sure the polarity is correct?
I have the VP180, and it sounds epic... hope you get it figured out, because you're missing out.
|
|
|
Re: Expert advice needed Dialog not sounding to good.
|
Joined: Mar 2016
Posts: 37
enthusiast
|
OP
enthusiast
Joined: Mar 2016
Posts: 37 |
You mention re-calibrating ARC, so am I to assume that you are running an Anthem receiver or pre-amp?
It would be far better off if you are, to provide a copy of the speaker calibration printout. as it's run in Windows, if you load something like CutePDF if you don't have a pdf print or aren't running windows 10.
From the few times that I have played with ARC, I found that the defaults didn't even come close to letting the speaker run as full frequency. There is quite a bit of configuration that you can do inside of ARC. For dialog you will need to give your center speaker a bump around the 120hz to 220hz. it could be that your room is sucking those frequencies down and your are loosing your dialog as a result of that. Yes I'm running anthem mrx510 and using the pre-out to a anthem MCA 50 amp. Your advice to filter of at 120hz frequency is too high? wont that make the sound tinny? I'll upload the print out from ARC so you guys could have a look.
|
|
|
Re: Expert advice needed Dialog not sounding to good.
|
Joined: Aug 2007
Posts: 3,488 Likes: 9
connoisseur
|
connoisseur
Joined: Aug 2007
Posts: 3,488 Likes: 9 |
sounds like a polarity problem like Brandon mentioned.
See Mojo's signature
|
|
|
Re: Expert advice needed Dialog not sounding to good.
|
Joined: Mar 2016
Posts: 37
enthusiast
|
OP
enthusiast
Joined: Mar 2016
Posts: 37 |
[quote=EFalardeau]sounds like a polarity problem like Brandon mentioned. [/quote
I recheck all the speaker connection and its correct. Maybe Im excepting too much from this speaker. Although The vp180 has a bit more spl than my previous Center which is 2 times small than vp180. I'm expecting a lot more for the size.
Does the vp180 hp use a different mids and crossover?
Last edited by shin204; 04/01/16 08:55 PM.
|
|
|
Re: Expert advice needed Dialog not sounding to good.
|
Joined: Aug 2007
Posts: 3,488 Likes: 9
connoisseur
|
connoisseur
Joined: Aug 2007
Posts: 3,488 Likes: 9 |
try swapping red and black on the vp180. its a quck test that doesn't cost anything
See Mojo's signature
|
|
|
Re: Expert advice needed Dialog not sounding to good.
|
Joined: Sep 2004
Posts: 11,458
shareholder in the making
|
shareholder in the making
Joined: Sep 2004
Posts: 11,458 |
I don't think you need to be looking at the HP. The 180 is very, very capable. Something isn't right. Make sure all drivers are working as well.
::::::: No disrespect to Axiom, but my favorite woofer is my yellow lab :::::::
|
|
|
Re: Expert advice needed Dialog not sounding to good.
|
Joined: Mar 2016
Posts: 37
enthusiast
|
OP
enthusiast
Joined: Mar 2016
Posts: 37 |
I don't think you need to be looking at the HP. The 180 is very, very capable. Something isn't right. Make sure all drivers are working as well. Do you have a good way of testing?
|
|
|
Re: Expert advice needed Dialog not sounding to good.
|
Joined: Oct 2014
Posts: 656 Likes: 3
aficionado
|
aficionado
Joined: Oct 2014
Posts: 656 Likes: 3 |
Put your ear up to each driver is the easiest. I had one that was popping or cracking, As I listened to each one found the culprit quite easy.
If any problem customer Service is great you could check their advice as well.
|
|
|
Forums16
Topics24,945
Posts442,484
Members15,617
|
Most Online2,082 Jan 22nd, 2020
|
|
0 members (),
1,228
guests, and
6
robots. |
Key:
Admin,
Global Mod,
Mod
|
|
|
|