Axiom Home Page Forums General Discussion Home Theater Denon AVR-3313 - Sound not as good as I expected

Hmmmm....maybe it's the mid-bass you lack in that room. That's the satisfying pop you hear from drums, etc. Boosting 50Hz to 80Hz really helps with that.

Ignore - tried to fix up image but no success.

I would do a factory rest and make sure it isnt set to 4ohm in the menu. This limits current and wont help your bass situation. Re-Run your speaker audyssey EQ auto setup.

The left channel is loading your corridor. Not sure where you sit, but Im sure the folks here can help you out if you post a sketch of your room. I see issues that will cause your problem.... like excess treble from lack of furnishings. Chasing bass with volume will continue to flood the room with harsh treble and load the corridor.

Definitely issues with too many hard surfaces and layout.

Hi,
I finally took all your comments and made some test.

First, I haven't found anywhere to configure the 4 or 8ohms parameters in my reveiver.

What I did that made the biggest difference about sound quality, which is now really better than before, was to change the BASS parameter LPF for LFE from 80hz to 250hz.

I thought that this parameter was only used if I have a subwoofer, which I don't have, and never care about it. But putting that parameter to 250hz, I feel that I have a better overall range of sound.

Sound is still about at same level, but really better quality.

I'll probably try to reste everything to default parameter and start all over just in case something is stuck somewhere.

Thanks for all your suggestions

[img]https://1drv.ms/u/s!AqluTV8Jwvkmgr0EehHLm3xSaRzTFg?e=pdroey[/img]

If you don't have a sub I'd try just setting all your speakers to Large and let the speakers handle their own response. Also try that with room correction off and in stereo direct ... that is if you have not tried this already