A/V Receiver vs Amplifier
|
Joined: May 2005
Posts: 295
local
|
OP
local
Joined: May 2005
Posts: 295 |
So I have been reading here and there...but a question remains. If someone has a 7.1 AV Receiver, ie. a Harman kardon...then why the need for a separate Amp. I guess my question is really....what are the benefits of having a separate amp (nad 7.1) plus a preamp? Just the amp power or is there something I am missing. My hk will do 120w per channel and that seems adequate...so why get a amp?
------------------------------------- Denon 4308 M80x2,VP150,EP600,4xQS8
|
|
|
Re: A/V Receiver vs Amplifier
|
Joined: Aug 2004
Posts: 6,379 Likes: 7
axiomite
|
axiomite
Joined: Aug 2004
Posts: 6,379 Likes: 7 |
>>My hk will do 120w per channel and that seems adequate...so why get a amp?
In general, if 120w per channel is adequate (which it is for most systems) then you don't need an amp. There are a number of cases (some overlapping) where an outboard amp or amps can help :
1. You have a huge honkin' room and like to play really loud so 120w/channel is not sufficient.
2. In some cases 120w/channel is sufficient but if you run the receiver up in that power range for a long period of time it overheats because all that heat is being dissipated into one heat sink array. This is also why some people go for multiple amps -- a 5 channel and a 2 channel or a stack of 2 channel amps. A few people on the board have had to replace a 5 or 7 channel amp with a stack of stereo amps to get around heat problems. Yes I know this is hard to believe.
3. Also, if you are running up near the power limits of the amp that is where many people feel that you can start to hear differences in sound quality between amplifiers. We're not sure whether this is related to output impedence, "soft clipping", or something completely different but many people do report a significant difference when going from a receiver "driven hard" to a power amp with much more hearoom. You would probably get the same effect from a 300w/chan receiver, of course, if one existed.
Bottom line is that if you are not running near the limits of your current receiver then going to separates probably isn't going to make much difference. If you are anywhere near the power limits of your current receiver then an outboard amp can help.
Note that the easiest/cheapest first step is to offload the mains to an outboard stereo amp using the pre-outs in the receiver, leaving more headrooom for the remaining 5 channels.
I don't know if the processors have additional features/performance or if it's just cheaper to buy a good processor than a good high-end receiver (if you're not using the amps) -- all that stuff has been out of my budget for... oh, the last 20 years
M60ti, VP180, QS8, M2ti, EP500, PC-Plus 20-39 M5HP, M40ti, Sierra-1 LFR1100 active, ADA1500-4 and -8
|
|
|
Re: A/V Receiver vs Amplifier
|
Joined: May 2005
Posts: 295
local
|
OP
local
Joined: May 2005
Posts: 295 |
Thanks BRIDGMAN.
Much appreciated explanation.
Now then if someone wanted a decent, not break the bank, amp to off load mains (new m60's which will take a few weeks to arrive) then what would you or anyone recommend?
i am budget conscious...especially after my huge axiom order. :-)
------------------------------------- Denon 4308 M80x2,VP150,EP600,4xQS8
|
|
|
Re: A/V Receiver vs Amplifier
|
Joined: Aug 2004
Posts: 6,379 Likes: 7
axiomite
|
axiomite
Joined: Aug 2004
Posts: 6,379 Likes: 7 |
I imagine the Outlaw M200 monoblock (1 channel) amp is still the best bang for the buck. 200w 8 ohms, 300w 4 ohms, $299 new, $230 B-stock. You would need two, of course.
Probably best to wait for other replies from people who have actually BOUGHT an amp recently
Last edited by bridgman; 06/04/05 04:39 PM.
M60ti, VP180, QS8, M2ti, EP500, PC-Plus 20-39 M5HP, M40ti, Sierra-1 LFR1100 active, ADA1500-4 and -8
|
|
|
Re: A/V Receiver vs Amplifier
|
Joined: Apr 2005
Posts: 2,339
connoisseur
|
connoisseur
Joined: Apr 2005
Posts: 2,339 |
The Oulaw mono is the option I think I will try first in looking for the same results.
|
|
|
Re: A/V Receiver vs Amplifier
|
Joined: Aug 2004
Posts: 6,379 Likes: 7
axiomite
|
axiomite
Joined: Aug 2004
Posts: 6,379 Likes: 7 |
M60ti, VP180, QS8, M2ti, EP500, PC-Plus 20-39 M5HP, M40ti, Sierra-1 LFR1100 active, ADA1500-4 and -8
|
|
|
Re: A/V Receiver vs Amplifier
|
Joined: Apr 2005
Posts: 1,155
connoisseur
|
connoisseur
Joined: Apr 2005
Posts: 1,155 |
bridgman: good post!!!!!!!!!
The Rat.
M80s, VP-150, QS8s,
SVS PC 20-39+, OPPO,
Onkyo 703s, Harmony 880
Sony 60" SXRD HDTV
|
|
|
Re: A/V Receiver vs Amplifier
|
Joined: May 2005
Posts: 295
local
|
OP
local
Joined: May 2005
Posts: 295 |
Thanks to all Again.
I am looking at the Outlaw 200's for my front channels.
My only concern...my receiver HKDPr2005 or maybe AVR7300 has the auto level adjustment with a microphone built in to the remote. When using this type of setup how are the levels for the fronts adjusted....? Sorry for sounding idiotic....just want to make sure I understnad this. I saw the article and it was pretty clear and concise.
------------------------------------- Denon 4308 M80x2,VP150,EP600,4xQS8
|
|
|
Re: A/V Receiver vs Amplifier
|
Joined: May 2002
Posts: 5,745 Likes: 17
axiomite
|
axiomite
Joined: May 2002
Posts: 5,745 Likes: 17 |
bridgman,
One should also add the idea about hard to drive speakers (not the M80s necessarily but speakers like electrostats). Many receivers do not support 4ohm loads, and even if they do it will tax a receiver more than a standalone amp (shutdown protection functions and such are still SPL dependant).
Not all amps can drive a 4ohm load either, but i believe there is alot more selection. For 8ohm speakers the selection for possible receivers increases dramatically.
"Those who preach the myths of audio are ignorant of truth."
|
|
|
Re: A/V Receiver vs Amplifier
|
Joined: May 2004
Posts: 1,201
connoisseur
|
connoisseur
Joined: May 2004
Posts: 1,201 |
Your receiver will adjust accordingly on its own with the outboard amps in place as long as you have it hooked up right.
Is there any reason not to get the newer hk635 if your going to add a couple of m200's?. You might save some coin this way.
*Michael* AV123 Refugee - X-LS Encore, X-Voce, X-Omnis, Elt-Dpa's Denon AVR-591 Magnavox NB500MGX BDP
|
|
|
Re: A/V Receiver vs Amplifier
|
Joined: Jul 2004
Posts: 4,444 Likes: 16
connoisseur
|
connoisseur
Joined: Jul 2004
Posts: 4,444 Likes: 16 |
It’s not that big of a deal. You just use the tone setting on the AVR, and the remote sensor will gauge the level, and then the AVR will balance the sound of all the channels to be the same in relation to wherever you happen to have the remote positioned. Then you go into the settings and add or reduce sound levels of the different channels to your liking.
I tried it with my 7200 and ended up going back into the settings and doing it by ear. Really, don’t worry about it.
Another thought though, with either the 7300 or DP, you shouldn’t need another amp. I wouldn’t waste your money. The 7300 has incredible current.
|
|
|
Re: A/V Receiver vs Amplifier
|
Joined: Aug 2004
Posts: 6,379 Likes: 7
axiomite
|
axiomite
Joined: Aug 2004
Posts: 6,379 Likes: 7 |
>>Another thought though, with either the 7300 or DP, you shouldn’t need another amp. I wouldn’t waste your money. The 7300 has incredible current.
I have to second this... hadn't realized your receiver was going to be something like a 7300. Between going with a 7300 vs. a (probably) less expensive 635 with a couple of monoblocks I don't really know which would be better... but if you're thinking about a 7300 I certainly wouldn't bother getting external amps for a while... the 7300 is quite a beast already.
I'm running a 630 with M60s and haven't felt even the slightest urge for more power yet. When I move into the new house the HT area will be quite a bit bigger so I might feel the need for power then... but by then I won't have any money anyways so it doesn't really matter
Chesseroo's point that an external amp will also help when driving 4 ohm speakers is also a good one... although HKs are pretty good with 4 ohm loads.
Last edited by bridgman; 06/04/05 10:05 PM.
M60ti, VP180, QS8, M2ti, EP500, PC-Plus 20-39 M5HP, M40ti, Sierra-1 LFR1100 active, ADA1500-4 and -8
|
|
|
Re: A/V Receiver vs Amplifier
|
Joined: Oct 2004
Posts: 139
veteran
|
veteran
Joined: Oct 2004
Posts: 139 |
I also agree, you could always add the amps later... try the H/K alone first, you may find it easily handles the job.
By the way, that is going to be one NICE system. M60's 4 QS-8's EP 500 and the VP-150 all powered by the 7300 should be SWWEEETT!!
How big is you HT room? Did you consider the M 80's? I only ask because they have the same power handling capacity as the other speakers.
Also nice choice on the H/K as it gives you good bass management options.
Be sure to give a review and pics once your set-up!
|
|
|
Re: A/V Receiver vs Amplifier
|
Joined: Apr 2005
Posts: 2,339
connoisseur
|
connoisseur
Joined: Apr 2005
Posts: 2,339 |
I agree that you should hold off for the amp until you've had a chance to get this all setup. You might find your listening levels do not warrant an amp.
|
|
|
Re: A/V Receiver vs Amplifier
|
Joined: May 2005
Posts: 295
local
|
OP
local
Joined: May 2005
Posts: 295 |
Thanks for the great advice all.
Also, thank you for the kudos on my axiom order.
I will try out my HK first and see what the sound is....I dont think I have to worry about amps either..for now. The room is not that big and I should be fine.
I will, of course, post pictures when my speakers are received and everything is ready to go.
------------------------------------- Denon 4308 M80x2,VP150,EP600,4xQS8
|
|
|
Forums16
Topics24,945
Posts442,480
Members15,617
|
Most Online2,082 Jan 22nd, 2020
|
|
1 members (BBIBH),
889
guests, and
3
robots. |
Key:
Admin,
Global Mod,
Mod
|
|
|
|