Get Free, Friendly, Expert Advice
Call 1-866-244-8796 or email

Designed and Manufactured in Canada Since 1980

AxiomAudio Blog

Blind Listening Tests

Sneak Peek into Axiom’s Current Research and Development

Axiom’s Newest Speaker: The In-Ceiling M3

A promise is A promise... Axiom's second home
Greg's pseudo-HT room
Who's Online
2 registered (Boltron, Ken.C), 41 Guests and 12 Spiders online.
Key: Admin, Global Mod, Mod
Forum Stats
13355 Members
11 Forums
23042 Topics
407471 Posts

Max Online: 378 @ 02/24/13 04:33 PM
Top Posters
Ken.C 17828
pmbuko 16308
SirQuack 13354
CV 11366
MarkSJohnson 11032
Meanwhile On Facebook

Love this review by Brad C! "Very impressed with my purchase: 2 High Powered M6...

(y) Great review from Tom H of his new surround speakers! "I love the surroun...

22 year-old Axiom System, still in showroom condition! Welcome home, old friends!

The end of a truly unique voice. RIP Joe Cocker - you were part of the soundtr...

Topic Options
Rate This Topic
#321960 - 09/10/10 12:41 PM Free test tones
Wuchak Offline

Registered: 12/18/09
Posts: 42
Here's a link to some free test tone files to help with stereo speaker placement. Just put your player into repeat track mode to keep the signal going. The tracks are about 1/2 way down the page.

I found the 1000hz tone very useful to adjust the toe in. Moving forward and back in my listening position there was a point where it audibly snapped into focus. That position for me was forward of my listening position so I reduced the toe in on the speakers by a 1/4 inch (this translates into a change of about 2" where I sit). Now I can move forward and back several feet with no noticeable change. Since 1/4" adjustments are hard to gauge I find that placing a laser level on the top of the speaker and then tracking the dot position on the wall makes it much easier. I use a piece of masking tape on top of the speaker at the front and back marked with a line for the center of the speaker to ensure consistent laser alignment. On speakers with straight sides this isn't needed but the angled sides of the Axiom's makes it necessary. I put a sticky note on the wall with a dot in the middle that aligns with the centerline of the speakers and my listening spot. Then measure out from that spot equally left and right and put stickies as targets to aim for when adjusting the speakers. This is especially helpful with speakers on spikes because you can change the alignment by 1/4" just by pushing down to set the spikes.

#322728 - 09/15/10 07:51 PM Re: Free test tones [Re: Wuchak]
Riker Offline

Registered: 10/16/06
Posts: 375
Loc: Ottawa, Ontario
Thanks for that ! I also like to tweak 1/4 inch at a time. But what I do is use these plastic channels that you put under appliances like fridges when you want to move them on hardwood floors or ceramic etc.. Spikes on carpet are hard to move precisely I find , so using these under the spikes, I can move my speakers in very small increments without having to lift them at all. Then when I have it just right, I take out the plastic rails..

Acoustic Zen Adagio, Veritas center, Axiom EP500, QS8s, Anthem AVM20, MC20,Adcom GFA7400

#322775 - 09/15/10 09:30 PM Re: Free test tones [Re: Riker]
jakewash Offline
shareholder in the making

Registered: 12/26/03
Posts: 10400
Loc: Calgary, Alberta
Some good ideas mentioned, thanks for sharing.



Moderator:  alan, Amie, Andrew, axiomadmin, Brent, Debbie, Ian, Jc 

Home  |  Corporate Info  |  Products  |  Message Board  |  FAQs  |  Warranty  |  Site Map  |  Privacy Statement   |  Contact Us

©2014 Colquhoun Audio Laboratories Limited
All Rights Reserved.