Hi, Joe and I were talking previously about using two VP150's from above and below a screen to get around the concerns having a center channel behind.
He mentioned that since the two speakers would need to run parallel you'd be putting a 3ohm load on your receiver instead of the standard 6 ((6*6)/(6+6)=3). Due to this you'd then need a seperate amp to power your center channels.
Is this the sort of thing I would need to accomodate this?:
Model 200 M-Block Amplifier
It's a "single channel amp" and although I don't know much about them this would be to amplify only one channel right? Which is what the parallel VP150's would function as?
P.S. Not saying this is the best choice for one of these..just wondering if it's the right type.