Originally Posted By: Jc
Originally Posted By: a401classic
Just in case, I ordered 500, 800 and 1000 mA fuses. I'll step it up as needed to the 1 amp level that JC said was OK. I'm just a little concerned making a 4X jump. Fuses are spec'd at a particular level for a reason.


Scott,

I replaced mine on my EP500 quite awhile back and it has been working flawlessly since then. That was a direct recommendation from Tom who had designed the amplifier. It was extensively tested with the 1000 mA with success.


I have been using 1 amp fuses for about 3 months now without a single blown fuse. That's the longest run I've had. I've also got all the 12v triggers re attached and operating nicely. No more getting up to switch the Ep500 on and off again - 'cuz the sub is just so far away wink

Scott

Scott

My HT