Axiom Home Page Forums General Discussion Advice from Axiom Owners Full metal bracket Ceiling mount QS8

I forgot to say that this is a livingroom with couch against one wall and loveseat against the other wall with an end table in the corner. Wires are to the outside ends of both of these pieces. Speakers would be just outside above the head of the furthest outside seats.

I guess I'll order the wall mounts this week. I have time because I just woke up and my speakers still aren't here yet.

I've had my QS8's ceiling mounted for 4 years and they work lovely.

Have a picture :



- D

The wall/ceiling mounts are included with the QS series are they not?

Wall, yes, but some people still prefer something sturdier for wall-mounting.

They come with a flush wall T-bracket, no ceiling bracket yo Adrian.

Adrian, They come with a flush wall bracket which is good if you have room behind your seating. My seating is up against the wall. Using a wall bracket that can angle down will help get the tweeters angled down towards my seating area better than the flush wall mount that comes with the speakers.

http://www.axiomaudio.com/fullmetalbracket.html#

Click on the close-up

Bob, not to be nosey, but you may not want to point the tweeter at your seating position. I think the point of the design is to avoid on-axis listening, which is why the front panel facing the listening room is the only surface without a speaker. Check with Alan, but I think you will get better rear imaging without the special bracket to aim it at you. Just tweaking your system without invitation...you can thank me later.

Thanks for the bit of info. What is the angle for anyway?