Re: Subwoofer Settings/Audyssey
|
Joined: Sep 2008
Posts: 4,116
connoisseur
|
connoisseur
Joined: Sep 2008
Posts: 4,116 |
Its not your fault Adrian you did nothing wrong. My Denon manual says to adjust the sub to the half way point as a starting point, however not all subwoofers are the same. In your case it is too high and on other subs that would be too low. Some are really sensitive and need little gain adjustment on the sub and receiver and others need a much higher voltage sent to them to perform properly. I always strive for a setting close to 0 give or take.
I’m armed and I’m drinking. You don’t want to listen to advice from me, amigo.
-Max Payne
|
|
|
Re: Subwoofer Settings/Audyssey
|
Joined: Jan 2004
Posts: 13,843 Likes: 13
shareholder in the making
|
shareholder in the making
Joined: Jan 2004
Posts: 13,843 Likes: 13 |
There is a master Audyssey thread on AVSforum in the Audio Subwoofer section, including a document with step by step setup. I would think if you had all your speakers/sub calibrated to say 75dB, speakers set to small, and 80hz crossover in the receiver, that would put in you a good starting point to then run Audyssey. Those or Audysseys recommendations anyway.
M80s VP180 4xM22ow 4xM3ic EP600 2xEP350 AnthemAVM60 Outlaw7700 EmoA500 Epson5040UB FluanceRT85
|
|
|
Re: Subwoofer Settings/Audyssey
|
Joined: Dec 2008
Posts: 6,928
axiomite
|
OP
axiomite
Joined: Dec 2008
Posts: 6,928 |
Did you guys use Audyssey or did you prefer to set up manually?
Hi, Randy. I was reading a thread on AVS an hour ago to get some info as well, thanks.
Last edited by Adrian; 03/26/09 03:31 AM.
Half of communication is listening. You can't listen with your mouth.
|
|
|
Re: Subwoofer Settings/Audyssey
|
Joined: Jan 2004
Posts: 13,843 Likes: 13
shareholder in the making
|
shareholder in the making
Joined: Jan 2004
Posts: 13,843 Likes: 13 |
Yeah, the Word document link in that master thread is a good article to follow, as well as the FAQ section on Audyssey's website.
M80s VP180 4xM22ow 4xM3ic EP600 2xEP350 AnthemAVM60 Outlaw7700 EmoA500 Epson5040UB FluanceRT85
|
|
|
Re: Subwoofer Settings/Audyssey
|
Joined: Mar 2006
Posts: 74
old hand
|
old hand
Joined: Mar 2006
Posts: 74 |
What I did with my Denon 789(1909) was to set the sub (EP500) to about 1/4, xover bypass (or as high as it goes) and phase 0. I run the first Audyssey pass which sets the distance and levels, then run the calc and check the level settings. Check to see if the sub's level is close to 0, this gives you room to adjust. Adjust the sub's level and rerun the first step,if needed. If it's at +/- 12 you don't have much maneuvering room. Then restart the auto setup and do all the Audyssey sweeps. After set the LPF to 120 and any speaker settings from large to small. Audyssey does not decide large/small for the speakers, this is done by the receiver based on the info supplied by Audyssey.
M80s,VP150,EP500,QS8(4)
|
|
|
Re: Subwoofer Settings/Audyssey
|
Joined: Jan 2004
Posts: 13,843 Likes: 13
shareholder in the making
|
shareholder in the making
Joined: Jan 2004
Posts: 13,843 Likes: 13 |
If I ever break down and get an Audyssey receiver, it will be interesting to figure 3 subs into the mix.
M80s VP180 4xM22ow 4xM3ic EP600 2xEP350 AnthemAVM60 Outlaw7700 EmoA500 Epson5040UB FluanceRT85
|
|
|
Re: Subwoofer Settings/Audyssey
|
Joined: Feb 2008
Posts: 1,005
connoisseur
|
connoisseur
Joined: Feb 2008
Posts: 1,005 |
No problem, just get a receiver with 3 sub outs
Last edited by onn; 03/26/09 12:03 PM. Reason: can't spell at 6 in the morning
|
|
|
Re: Subwoofer Settings/Audyssey
|
Joined: Sep 2004
Posts: 11,458
shareholder in the making
|
shareholder in the making
Joined: Sep 2004
Posts: 11,458 |
If I ever break down and get an Audyssey receiver, it will be interesting to figure 3 subs into the mix. Randy, get one with Audyssey666, it'll EQ spirit peaks.
::::::: No disrespect to Axiom, but my favorite woofer is my yellow lab :::::::
|
|
|
Re: Subwoofer Settings/Audyssey
|
Joined: Jan 2004
Posts: 13,843 Likes: 13
shareholder in the making
|
shareholder in the making
Joined: Jan 2004
Posts: 13,843 Likes: 13 |
onn, not aware of to many receivers with 3 sub outs, only the highest end Denon's have it as far as I'm aware... $$$$
M80s VP180 4xM22ow 4xM3ic EP600 2xEP350 AnthemAVM60 Outlaw7700 EmoA500 Epson5040UB FluanceRT85
|
|
|
Re: Subwoofer Settings/Audyssey
|
Joined: Dec 2008
Posts: 6,928
axiomite
|
OP
axiomite
Joined: Dec 2008
Posts: 6,928 |
I just reran Audyssey with the sub level at slightly less than 1/3, the crossover on bypass, and the phase control at "0". This netted me a sub reading of a more reasonable -7db vs -12db, I may go to 1/4 on the sub level but it's much better now...no booming while watching TV, and still plenty of bass in the movies. Tks, all...Adrian.
BTW, Mark...that Audyssey666 is a very hot seller from what I've heard.
Half of communication is listening. You can't listen with your mouth.
|
|
|
Forums16
Topics24,949
Posts442,510
Members15,619
|
Most Online2,082 Jan 22nd, 2020
|
|
0 members (),
1,072
guests, and
3
robots. |
Key:
Admin,
Global Mod,
Mod
|
|
|
|