Axiom Home Page Forums General Discussion Advice from Axiom Owners EP500 - No / Barely any LFEs

The receiver is 40' across the house in a rack.

Don't ever loose your remote.

OK, I didn't read carefully. Steve is probably right.

Ahhhh! Don't use Audyssey. You are getting to much voltage drop in that wire. Your measurements will be off. Get a Radio Shack meter to calibrate.

If you haven’t already I wouldn’t bother with a tripod for the Radio Shack meter it’s just not that sensitive. OTOH, a stand can be useful for the Audyssey mic but nothing fancy is needed. I just made a “T-Ball” style stand out of spare wood I had lying around.

I would aim the meter at the ceiling just make sure if you are holding it or standing near is not to stand between the meter and the speaker you’re measuring and don’t breath heavily on it might skew the reading and frankly it‘s a little strange.

I’m with Steve (Sroode) on the Audyssey issue. I’ve gone back to not using it as I’ve been doing a lot of tweaking and running Audyssey is a pain made even worse by adding height and wide speakers. I just use my Onkyo’s test tones and a tape measurer. I will try Audyssey again once I’ve got everything sounding the best I can without it.

1k on RF remotes. Makes me even happier my IR blasts through the curtains and French doors into the office with my equipment rack.

Well I got one of those little GorillaPods, wanted one for my camera anyway.

I ran Onkyo setup:

Equalizer:None
Speaker Distance: USed a tape measure
Set crossovers per Docs recommendations:

Front 80
Center 80
Surrounds 80
Rears 90
SW 120

And ran the pink noise setup: Set SW @ 12:00, O phase, SSF: 0ff CO: 120

Here are my new "trims"

Left: -0.5 (W22)
Center: -4.0 (W150 & W100)
Right: -1.5 (W22)
SR: -4.0 (QS8)
SBR +2.5 (QS4)
SBL +2.5 (QS4)
SL: -3.0 (QS8)
SW -.05 (EP500)

Watched some LFE scences, and bumped and SW volume at bit.. watched more and then went back into setup and bumped SW DB to 0.00.

I think I like it much better. Time will tell. (Next I'll have to pick a day to mess with the equalizer settings)

Thanks All