It shows a picture of a room and cycles through all the speakers one at a time about every 5 seconds. So as it cycles, you have to keep hitting the button on the Denon remote to keep up with the speaker your on. It does not give you enough time to finish each speaker, so it is like a merry go round, very frustrating. Then the Denon times out if you don't keep adjusting the levels up/down, so you start back on the LF, but if the software is on the Rear surround your out of synch.

Sorry, this really pisses me off.

I"m back to using the Denon and trying different locations on the 600 away from the corner, but having similar problems. I think the problem is this dang Denon. There is no reason I should have to be at -11dB with the 600 on MIN and the lowest SPL I can achieve is like 75dB's no lower. This screws up the calibration for the other subs/speakers. I have to crank the 350's almost to MAX, and my surrounds are on +12 (the highest it can go and other speakers about +7.

I know I'm going on and on, but this should be easier than this.

M80s VP180 4xM22ow 4xM3ic EP600 2xEP350
AnthemAVM60 Outlaw7700 EmoA500 Epson5040UB FluanceRT85