Originally Posted By: sirquack
I wonder if Jakeman has experience this issue with the 600 sucking the output from the 600 when using other subs?


Nope. I used an Arcam avp700 processor which is also has a high output signal. In fact at one time I had 3 600s daisy chained without any issue. I've always thought the source of many of your problems was that old Denon receiver you use.

Too bad you are having so many problems dialling in those subs. I've always recommended a minimum of dual subs in any HT because the benefits of smoother response and greater headroom. However, that assumes you can calibrate and dial them in properly with each other and the mains. One of your measurements looked pretty good with all subs driven.

What's up with your SMS? Are you using the latest firmware.

John