Yup, that did the trick.
Also ran the Audyssey MultiXT calibration this morning, with 5 listening spots. Sounds pretty good on first blush, but it did set my VP100 to 40 Hz, which confuses me. Or is that the one that the receiver manufacturer does?
Audyssey checks for the -3dB point for all the speakers and then tells your avr; in this case the -3dB was measured at 40 Hz.
it often is different from the manufacturer's specs as it depends on speaker placement.
my rear speakers are R.S. Minimus 7; they're supposed to go down to around 100Hz (-3dB), but the way they are positioned, Audyssey reports a cutoff freq. of 40 Hz.
in this case, i just changed the x-over freq. to 100 Hz.
also, i don't know how many mic positions your version of Audyssey has, but you should always use all of them; this way, Audyssey collects the max. amount of data to make the best possible corrections.
