Korkster - The surest way to make sure you wire the speakers properly is to connect each DSP out to the amp channel then to the speaker, one driver set at a time.
Front woofer DSP out > AMP Channel 1 in > Woofer input on speaker
Front mid DSP out > AMP Channel 2 in > Mid range input (front) on speaker
Do this on all ten sets of drivers, and you will be fine. It's tedious, but effective.
Make sure you put the speakers so the slight angle on the rear angles the drivers out. Start with the speakers with no toe in, and experiment over time.
They are also so neutral and clear, you may not be "blown away." Nothing jumps out at you - but you will start hearing details unlike ever before. You will notice you can listen for hours with no fatigue. You will realize the limiting factor is the quality level of the recording.
