I've been doing manual setups lately and skipping any auto room correction for the HT. If doing two channel I hit the "direct", "pure", or what ever the 2 channel "don't modify the input" button is ... I always set my speakers to large if not using sub. If using a sub then I allow the receiver to do the cross-over (setting the subs x-over out of the way ... usually 150 hz) ... then decide if large or small is appropriate for the system (i.e. large floor standing speakers like the M80 or M100 are set to large, an M22 or M3 to small. The exception on large floor standing is if the amp is marginal, like most receivers, I may set them to small and let the Sub do the low-end heavy lifting)

Last edited by rrlev; 09/11/20 03:03 PM. Reason: adding when I set Large or Small