Oppo connection question
|
Joined: Jun 2009
Posts: 142
veteran
|
OP
veteran
Joined: Jun 2009
Posts: 142 |
Hi everyone I also own the new Oppo bluray player and I also own the Sherwood Newcastle R772 AV that axiom sells. I am new to all this so this may sound like a dumb question. Could someone looking at the specs of my av tell me the best setting for my Oppo? I have it a bitstream now should I change it can my AV decode everything? I get my complete axiom 5.1 set up this week and I really dont know how I should have it set up. I was just going to do it trial and error. My set up is 2 M22s the VP100 center and 2 QS8s for surround and the EP175 sub. I have both HDMI and the 5.1 analog cables if needed. I have all this in the corner of my bedroom with a 46" sony. Hopefully I will be an expert at this stuff a few months but if someone could just give me the best settings for my system it could save my a lot of time. I am just very anxious to start playing movies and music this week.
|
|
|
Re: Oppo connection question
|
Joined: May 2009
Posts: 670
aficionado
|
aficionado
Joined: May 2009
Posts: 670 |
Do you know if your receiver will process the newest sound formats... Dolby TrueHD and DTS Master? If it will, simply run HDMI to the Sherwood and set the Oppo to bistream. If it won't, but will process audio through HDMI, you can set the Oppo to PCM.
Some players will also do the newest audio formats through analog, but you only need to use this if your receiver will not process them AND it doesn't have HDMI (this is what I currently do as my receiver is a whopping 2 years old)
|
|
|
Re: Oppo connection question
|
Joined: May 2009
Posts: 670
aficionado
|
aficionado
Joined: May 2009
Posts: 670 |
Ok I just looked it up, the Sherwood will process all formats through HDMI which makes this very simple. Run HDMI from Oppo into the Sherwood. Set Oppo HDMI out to bitstream. Enjoy best sound quality available today :).
Last edited by Potatohead; 07/06/09 03:47 AM.
|
|
|
Re: Oppo connection question
|
Joined: Sep 2008
Posts: 4,116
connoisseur
|
connoisseur
Joined: Sep 2008
Posts: 4,116 |
You could use either the analog or HDMI with the OPPO but the HDMI/bitstream option that Potatohead described above is the best as well the easiest connection for your OPPO. HDMI/bitstream will allow you to experience all the new audio formats and it will also let you use your Sherwoods superior bass managment settings as opposed to when using analog cables you have to use the OPPO'S bass managment and calibration which is limited and harder to setup.
I’m armed and I’m drinking. You don’t want to listen to advice from me, amigo.
-Max Payne
|
|
|
Re: Oppo connection question
|
Joined: Jun 2009
Posts: 142
veteran
|
OP
veteran
Joined: Jun 2009
Posts: 142 |
COOL that means I had it right at bitstream just wanted to make sure. My next question is my AV has this set up microphone should I use it once I get my system this week or is it a waste. I have never used one but I can easily follow the instructions but I want to make sure its not a waste of time.
|
|
|
Re: Oppo connection question
|
Joined: Nov 2008
Posts: 1,789
connoisseur
|
connoisseur
Joined: Nov 2008
Posts: 1,789 |
...this may sound like a dumb question. Don't worry it's just like my history teacher used to tell us, "there is no such thing as a stupid question... just stupid people who ask questions". lol, just being silly. Ok so let me get this straight, the internal decoding of the Oppo player is not as good as the newer recievers decoding capabilities? Because I was hoping to get the Oppo player since my Denon is also older and doesn't decode the new formats, nor does it have HDMI. So what I'm beginning to understand is that the analog connections don't sound as good as the HDMI connection? I don't really understand why that would be? As much praise as I've read about the new Oppo player on here and on other sites I would have thought the internal decoding of the player would be just as good as any reciever on the market?
My Stuff :
M80's QS8's VP150 EP800 Denon 4802 Emotiva XPA-3 Samsung BD-P3600 Sharp 65 Inch Aquos LCD
|
|
|
Re: Oppo connection question
|
Joined: Feb 2009
Posts: 3,466
connoisseur
|
connoisseur
Joined: Feb 2009
Posts: 3,466 |
The Oppo has great analog sound quality (perhaps better quality DACs than found in many receivers). That isn't the issue. The limitation is you have two settings for the cross over: Off or 80 Hz for all channels set to small.
I've found 80-all-around to be a pretty good fit for me; even when I'm given a choice.
Pioneer PDP-5020FD, Marantz SR6011 Axiom M5HP, VP160HP, QS8 Sony PS4, surround backs -Chris
|
|
|
Re: Oppo connection question
|
Joined: Sep 2008
Posts: 4,116
connoisseur
|
connoisseur
Joined: Sep 2008
Posts: 4,116 |
As chris mentioned the DAC in the oppo will be high quality. You will get great sound quality using the analog setup (I use it with the Panasonc BD55 because I do not have HDMI receiver) however the crossover will be fixed at 80 and I believe you will have to setup the speakers as small/larbge as well as set the speaker levels in the menu settings of the OPPO (this is more difficult than setting up a receiver). Also any auddessy/YPAO or room correction/equilizations will not be used because the receiver is simply used to amplify the signal.
It is more likely you will notice a difference in a poorly calibrated setup than would be a dac. A common complaint of the analog setup is the LFE lacks compared to when using the receivers bass management.
I’m armed and I’m drinking. You don’t want to listen to advice from me, amigo.
-Max Payne
|
|
|
Re: Oppo connection question
|
Joined: Nov 2008
Posts: 1,789
connoisseur
|
connoisseur
Joined: Nov 2008
Posts: 1,789 |
I see, so you have to set the speakers to 'small' eh? Wow that does suck balls since the M80's produce such beautiful bass!!! I guess I'll be looking at getting a new Denon after all. Such a shame since my 4802 is an awesome reciever minus the fact that it doesn't have HDMI.
I was really hoping the $500 dollar Oppo would be my cure-all. Now that I'm looking at spending at least $1000 dollars on a 3808 I wonder if I'd be better off just getting a run-of-the-mill BD player to keep costs down. I really wasn't wanting to have to spend $1500 to get the best picture/sound quality possible. Gosh does this hobby ever suck money! Lol
My Stuff :
M80's QS8's VP150 EP800 Denon 4802 Emotiva XPA-3 Samsung BD-P3600 Sharp 65 Inch Aquos LCD
|
|
|
Re: Oppo connection question
|
Joined: Sep 2008
Posts: 4,116
connoisseur
|
connoisseur
Joined: Sep 2008
Posts: 4,116 |
Micah this is a great article explaining how to setup Multi-channel analog and explains its differences in setup compared to using HDMI. http://www.bigpicturebigsound.com/How_To...s_And_Why.shtml
I’m armed and I’m drinking. You don’t want to listen to advice from me, amigo.
-Max Payne
|
|
|
Forums16
Topics24,945
Posts442,484
Members15,617
|
Most Online2,082 Jan 22nd, 2020
|
|
0 members (),
1,228
guests, and
6
robots. |
Key:
Admin,
Global Mod,
Mod
|
|
|
|