Audyssey Calibration Question
|
Joined: Sep 2009
Posts: 212
local
|
OP
local
Joined: Sep 2009
Posts: 212 |
Hey all. I have a little bit of a different question re Audyssey setup today...
Can I place the calibration-mic outside the box* for L and R measurement positions?
I've moved my HT to a new room (a whole new House, actually) and the box* is more narrow than it used to be.
I am doing my Calibration with 6 positions: - main - Left as far as I can go within the box - Right as far as I can go within the box - Repeat all above but forward 2.5 feet
I don't think my spacing is adequate as most of my Crossover points are coming out too high for my liking.
M22: 100 VP150 80 QS8 120
In my last room, when this happened, I used wider spacing in my calibration and my crossovers came out much better... but I don't have that luxury here as the front main positions are relatively narrow.
If the 1st measurement (main seating position) is used to calibrated distance and timing, can I do the other measurements outside the box* as they should only be used for EQ calucations?
Thanks snazzed
Edit: When I say, "the box" I am meaning within the bounds of the innermost left and right speakers so stereo imaging is not lost. In my case the front mains are the innermost.
M22, VP150, QS8 <--all v2 Sub: Outlaw LFM1-Plus Denon AVR1910, Sony X900-65"
|
|
|
Re: Audyssey Calibration Question
|
Joined: Dec 2003
Posts: 10,420
shareholder in the making
|
shareholder in the making
Joined: Dec 2003
Posts: 10,420 |
I believe going outside the box to be unconventional but you really have nothing to loose, try it out and see if you like the results better; if not simply re-run within the 'box' and then decide if you like no Audyssey vs. Audyssey.
Jason M80 v2 VP160 v3 QS8 v2 PB13 Ultra Denon 3808 Samsung 85" Q70
|
|
|
Re: Audyssey Calibration Question
|
Joined: Jan 2004
Posts: 13,840 Likes: 13
shareholder in the making
|
shareholder in the making
Joined: Jan 2004
Posts: 13,840 Likes: 13 |
Audyssey has always said you should never take measurements "outside" the speakers being measured. Those measurements are not unrealistic in my opinion. All my Q's are at 120, and the other measurements don't seem out of the question really. Are you taking measurements at "ear" level for the different seats or possibly forming a bubble around those seats? You also don't want other furniture in the way between the speakers and the mic, or have the air running.
Last edited by SirQuack; 09/14/11 01:34 AM.
M80s VP180 4xM22ow 4xM3ic EP600 2xEP350 AnthemAVM60 Outlaw7700 EmoA500 Epson5040UB FluanceRT85
|
|
|
Re: Audyssey Calibration Question
|
Joined: May 2002
Posts: 10,654
shareholder in the making
|
shareholder in the making
Joined: May 2002
Posts: 10,654 |
By, as to where those other readings should be taken, they shouldn't be widely spread about the room(i.e., "outside the box"), but regardless of how many more are made, they should be clustered fairly tightly. See this Audyssey diagram and discussion which illustrates this.
-----------------------------------
Enjoy the music, not the equipment.
|
|
|
Re: Audyssey Calibration Question
|
Joined: Jan 2004
Posts: 13,840 Likes: 13
shareholder in the making
|
shareholder in the making
Joined: Jan 2004
Posts: 13,840 Likes: 13 |
M80s VP180 4xM22ow 4xM3ic EP600 2xEP350 AnthemAVM60 Outlaw7700 EmoA500 Epson5040UB FluanceRT85
|
|
|
Re: Audyssey Calibration Question
|
Joined: Sep 2009
Posts: 212
local
|
OP
local
Joined: Sep 2009
Posts: 212 |
Thanks for the feedback guys. I love this forum.
Audyssey guide says try not to go "too far" outside the box. I'll try with an extra 6" on each side.
------------------------ @SirQuack: In my last room my Crossovers were much lower:
OldHouse NewHouse M22s: 60 100 VP150: 80 80 QS8: 90 120
I manually bumped the M22s up to 80 though. I think I was getting a lot of reinforcement off 1 wall with the R speaker being corner loaded.. ------------------------
I'll try with the slightly wider positions and report back.
snazzed
M22, VP150, QS8 <--all v2 Sub: Outlaw LFM1-Plus Denon AVR1910, Sony X900-65"
|
|
|
Forums16
Topics24,945
Posts442,486
Members15,617
|
Most Online2,082 Jan 22nd, 2020
|
|
1 members (rrlev),
1,125
guests, and
2
robots. |
Key:
Admin,
Global Mod,
Mod
|
|
|
|