Just picked up a new sub, and curious about setup with audessey. I was trying to follow another thread,but was not doing so well. To get the most possible bass after calibration, where should I set the crossover on the sub for the cal. Fronts Freq. low at 60hz. Possible crossover (low pass filter) on sub is 40-150hz. I think I understood from the other thread, that the volume knob on sub should be set in the middle.
Set the volume in the middle to start. If Audyssey sets your trim -12 or lower, your volume is too high and you need to start over. Same thing if the trim is set to +12 (sub volume too low).
Just a few quick tips.
Always use a tripod with the supplied mic.
The mic should be above the back of your seat
The mic should not be too close to a wall
