Jason,

VERY nice. That boomieness is what I encountered when I put my riser in. I was hoping a nice dense insulation in your riser would help a bit. I was actually thinking about cutting the holes in the front of my riser (my internal supports go front to back instead of side to side). Did you only but the holes in the front board? If so, is it too late to pull the top off and do that to the other supports?

It looks great Jason, lot's of hard work there!


LFR1100 Actives,QS10HPx2,QS8x2,EP800,M3x4,M3x2 (Wood),M5HPx2 (Wood),AxiomAir,ADA1500-8,ADA1500-7