doh!
I have signal ground and shield mixed. Just to recap.
XLR male, hot pin 2, signal ground pin 3 and open shield to pin 1, On RCA hot pin 2 to tip and signal ground to pin 3. This is how I intend to terminate. Will this still result in the Ice module going into -10dBV mode?
Solid-State
PS I'm also curious why a module populated with only one in and out produces a hum in that channel? If you connect an in to the unused chan or in and a speaker the hum is completely gone... why?
Last edited by SolidState; 09/17/09 04:59 PM.