Working on finishing my deck this weekend, I used a skilsaw on it's side while standing on a ladder cutting the tops off of 6x6 posts all at awkward angles. The skilsaw was a hand me down from my dad so I think it was made in the 50's out of cast iron! (i.e. it is not a modern lightweight version). Multiple cuts were required on each post as the blade could not be dropped enough to get through the full width of the 6x6's.

That may not be a big deal for some of you, but for me this was a death defying feat. The task had to be done but was still not one of the smarter things I've done. I had a well deserved beer when the task was done.

Dan
On-Wall M5HP LCR, QS8 & EP500 in 7.1