I contacted Freud and they suggested I use one of their "Thin Kerf Glue Line" ripping blades, either LM74R010 or LM75R010(both 30T) on my table saw and use the LU74R012(80T) "Thin Kerf Ultimate Cut-Off" blade on my mitre saw. All blades have the perma shield coating on them.
Thank you for all the suggestions.
I too am a big fan of Freud blades. I have the same "80 tooth, ultimate cut-off" on my miter saw and although it makes for incredibly smooth cuts, I don't really like it. The previous Freud 60 tooth blade I had also made very clean cuts, but with the lower number of teeth (and the resulting larger capacity for sawdust between the teeth, they cut faster.
Good luck!