I covered an EP600 with cherry veneer. Sanded the leading edges a bit to put a slight radius on them and just wrapped them tightly with the veneer. Then I capped the top and bottoms. Roughed up the vinyl with a ROS and 150 grit. Used contact cement. Your technique looks cleaner. Nice work!
Are you saying that you used one single piece of veneer and went right around the whole sub box? How did you manage to get the veneer to bend at a 45 or 90 degree angle. I considered veneering over the vinyl but in the end it just seemed best to remove the vinyl, wood veneer is just too expensive to take a chance imho.
