Quote:

So, when you do that on your systems, do you see the M80 woofers and mids moving?


No, mains are silent for any tone reasonably below the set 80 Hz x-over (say around 65 Hz or so). It sounds like there is something not right in your processor's setup, such as LFE set to "FULL + Sub" (but I realize you stated this was not the case). Even if it were, 10Hz is really much lower than the M80s could deal with anyway. I'm confused

* EDIT * After reading the other thread in Technical Questsions, I see that it was the Direct-Mode in the Dennon's, but I stand corrected in that the M80s apparently will attempt to handle frequencies as low as 10 Hz!

Last edited by dllewel; 05/29/07 04:41 AM.
-Dave

M80s VP150 QS8s EP500s
ravenmanor.com/cinema/