Turn off audyssey and try the manual setup settings I suggested. If you know where the sub control on the receiver is now this should take only but a few minutes to adjust it from -12 to +2 . This is a much easier troubleshooting method, takes less time and has less variables at play.

You have to figure out first if this is a settings issue or the sub. If we find out it is a settings issue then run audyssey after. All subwoofers are different and manufacturers are constantly changing the amp sections in them. Some might need a lot of voltage from the pre-out section, some might need very little and some are fine set at 0.



I’m armed and I’m drinking. You don’t want to listen to advice from me, amigo.

-Max Payne