Oh, the 94 has the power to run everything and it is 4 ohm stable....no problem. At -15db setting on the dial its enough to make the neighboors mad. At 0 on the dial you can no longer function and your vision goes blurry.
hijack away you anklebitters
Page 74 of the SX94THX manual recommends using only 8 ohm speakers with this receiver. It states you can use 6 ohm speakers, but you have to make a change in the setup:
http://www.pioneerelectronics.com/pio/pe...uctions0807.pdf"Switching the speaker impedance
We recommend using speakers of 8 Ω with this system,
but it is possible to switch the impedance setting if you
plan to use speakers with a 6 Ω impedance rating.
1 With the receiver in standby, press STANDBY/
ON while holding down the SETUP button.
2 Select SPEAKER using /, then select 8 Ω or 6 Ω
using /.
• SPEAKER 6 Ω – Use this setting if your speakers are
rated at 6 Ω.
• SPEAKER 8 Ω – Use this setting if your speakers are
rated at 8 Ω or more."
Although it does not have a 4 ohm setting, it may help.
