Originally Posted by CV
Originally Posted by Canesfan27
Which brand of HDMI do you like to run? I needed a 30 ft cable and went with an active cable because I was worried about not getting full 4k 60hz at that length of cable.

I know you weren't asking me, but I'm also curious what everyone is doing for longer HDMI cables. I got a 30' Furui cable a while back, and when my picture kept going out, I was afraid it was my new TV. Finally isolated the problem to the cable. They replaced it at no charge, but then the replacement failed very quickly too, so I'm done with that brand. I've had good luck with BlueRigger, but I haven't had to do any HDMI 2.1 stuff yet. Seems like there are a lot more options out there now, so I wouldn't know where to begin.

From everything I've read once you go over 35 feet you need to use an active cable and runs longer than 50 ft right now cannot support 4k @ 60hz. I went with a monoprice active cable. I'm running electrical conduit up to the projector to make it easier down the road to replace any HDMI cables because I know technology will improve and also the wires will eventually start to fail.


LFR1100
VP180HP
EP600
M3 In Ceiling x 4
M5OW
M2 - Atmos rears
ADA1500.5
M3 Outdoor Speakers
ADA 1000.8