So far I've been lucky and havent formulated Tannerite. laugh

An OLFA knife as a razor blade has dealt with all the squeeze out up until now. It scrapes off MDF pretty easily once hardened. There was no way to clean as I went with water and still get it all done in a day. Too much work. Since the ply edge is exposed it will have to be sanded anyway I figured. Whenever I belt sand I just cover the entire area with pencil shade, go over to remove shade, repeat, repeat etc. till smooth. It is fast and pretty consistent when levelling out uneven surfaces.

By the way the lepage "pro carpenters glue" I'm using grabs quick and starts to gum in a few minutes. Pretty nice stuff to work with. Time to mask all of the holes now before things get dusty.