Going to give wood essence a call today.

I'm trying to decide between System Three Mirror Coat pour on epoxy vs their Clear Coat Top Coat products. If anyone has an opinion your thoughts would be appreciated. I'm trying to spend more on the finish product to save time in this step. I can brush on poly and sand. But that will tack on a lot of time. Doing a high gloss mirror finish on these cabinets on all surfaces but the bottom. It will be painted gloss black and left at that step. A 1.5 Gallon kit will be required for this project in either choice.

Pour on resin- 2 part product cures hard. Easy application. Perfectly flat mirror finish in one go. No sanding. Have to do one side at a time. Have to babysit edges to prevent drips from rolling over sides. Must do a thinner coat than they recommend to prevent issues. Must ensure surface is perfectly clean and level. Results are stunning from online pics. http://www.woodessence.com/MirrorCoat-P145C41.aspx

Clear coat resin- 2 part product cures hard. Brush or roll on. Water clear finish. Deep grain penetrating. Can apply multiple coats to thicken up. No sanding. Cures faster than mirror coat. Is 100% solids with crosslink hardener so it is super strong and basically sealed forever. A perfectly prepared surface is not required. Open grain ok. http://www.woodessence.com/Clear-Coat-P146C41.aspx

Both products should allow me to work indoors where it is warm\consistent and I wont have to move speakers back and forth. I can also control the dust levels better inside. They are not fumey from what I have read but Wood Essence will have to advise.