Something is (finally) in the works....

Just over a week ago, I was asked by my wife and kids what I wanted for Father's Day. The next day I gave them a printout of the following plus a shot of the exact 49" x 97" x 3/4" MDF panel at Home Depot.

I said, I would like that sheet of wood cut to these specs.



I am a couple of hours into the project. Which isn't as far as you would think, but I am getting good and using a sircle jig with my router. I will post more pictures in the near future.

In the mean time, yes, that is almost 4 cuft...

I am using the full 4" port from Parts Express:


The woofer is aDayton Audio RSS315HF-4 12" Reference HF


And the Amp is a BASH 320 amp from SVS (same as what is in my current SVS 20-39PCi). I had an amp issue back in 2004 with my SVS and they sent me a brand new one. They never asked for the old one back, and in the middle of the "we shipped it" process, someone at AVS had a solution to my problem. I don't recall the solution, but it fixed what was happening and I never did swap amps around. SVS was told of what happened, and never asked for the new amp back even then.

It looks like this, but isn't installed:

Farewell - June 4, 2020