Anyone work with veneer much?? I haven’t, just vinyl laminate. I imagine they are similar to work with, but maybe not??

I ask because I’m thinking about covering an EP 600 I have with Hickory veneer. I have Hickory hard wood floors and would like to put this sub in that room. The sub has Boston Cherry vinyl on it now. I think I can run a ROS over the case to rough it up a bit(after I pull everything off of it), then use contact cement to adhere the veneer and use a laminate trimmer to cut off the excess. Maybe sand the seams down a bit, then finish them.

Trying to navigate around the non-90 deg corners is going to be a bitch. I think Axiom groves the veneer somehow, then rolls it over the corners.

Any suggestions / ideas / insight would be appreciated before I tear into this thing.